Free shipping is only valid on total purchases of $199 or more and ground shipments within the contiguous 48 states for products weighing less than 150 lbs. Special handling fees may be required for some products.Shipping fees will be added for all orders under $199 or that include oversized items or any item of 150 lbs or more. Please contact customer service if you have any questions.
AW Direct Elite Series Winch Cables can also be known as: winch line, wire rope
carrier cables, and rollback cables. The Fiber Core Winch Cables provide superior flexibility. When pressure is exerted on the working winch cable, the lubricant
reservoir gives off lubricant to minimize the wear of wire on wire, assuring
longer service life. These winch cables also come with an Alloy Self-Locking
Swivel Hook that will not open when under load, providing a secure, safe
connection. This swivel hook will rotate as it is reeled into the drum so that
it will wrap and lay better.
This Pivot Pin Kit is for use with Vulcan 804, 831, 860, 870 and 880 Wrecker
Wheel Lifts. This kit also fits all Vulcan Car Carrier Wheel Lifts and
Century/Champion 10 Series Car Carrier Wheel Lifts built in 2002 or newer with
a Vulcan style crossbar. This Kit has a 1-1/4" diameter pivot pin that is held
in place with an allen head bolt and washer on the top.
Available in Classic, Tower's Edge or Heavy Duty webbing these 2" straps come
with a flat snap hook attached at one end of each. A Cordura sleeve provides
added protection on each strap. These straps are commonly used on Dynamic Tow
Trucks. Wheel Lift Straps are perfect for securing vehicles tires to any wheel
lift.
This Sheave Casting from Miller Industries is used in the Boom Swivel Assembly of Century, Holmes, and Vulcan Wreckers. This pulley
measures 6" in diameter, 1" wide, and it has a 1" diameter hole. Please see the brochure tab for a list of breakdowns. This part can
be used to replace Part Numbers: 9050504 and 7766200.
This is a 1" Snap Ring by Miller Industries. This snap ring is used on the
wheel lift extend cylinder pin. This snap ring secures the pin in place. To
view the part schematic click on the Brochure tab.
This straight grease fitting is used to dispense grease into a mating part using a grease gun. It is made from steel with a zinc finish and comes with a ball check. This part has replaced part number
This is a replacement boom end sheave shaft retainer for light duty wreckers by
Miller Industries. This retainer mounts to the boom end swivel and secures the
sheave shaft in place. It secures the shaft by sliding into a groove cut into
the shaft, which prevents the shaft from moving. To view which models this
retainer will fit please see Features below. To view the part schematics,
please click on the Brochure tab above.
Hex Head Cap Screws are designed for simple assembly into a tapped hole. They
have a specially designed washer face under the head and a chamfered point. The
zinc plating slows the process of corrosion. This 1/2" Cap Screw is used on the
Bed and Frame Assembly of Century, and Vulcan Car Carriers.