Zacklift Fifth Wheel 25,000 lb. Stiff Legs

Fifth Wheeler 25,000# Stifflegs are the exclusive design innovation of Zacklift International. Engineered with the same rugged power as the permanently mounted Big Foot Series, the Fifth Wheeler Legs are bolted into place on the mounting beam. 100% factory installed and plumbed; the height, angle and travel distance are all engineered by the installation experts at Zacklift. No labor is required for immediate use. The two section lever operated valve is completely installed in-series with the Zacklift valve. All plumbing is cleanly routed through the interior of the Fifth Wheeler beam at the Zacklift factory. Dual 5" D-rings are standard equipment on the Fifth Wheeler Legs.

The Fifth Wheeler Legs carry a 25,000 pound push rating, measured by the strength of each leg. Exterior housing measurements are 5 x 5 x 3/8", interior 4 x 4 x ve anchoring power. The 18" super wide-surface foot pad is designed for the dual purpose of flat surface stabilization and angled recovery anchor stabilization. A single one-man, one-step operation pulls and replaces a single pin to move between the trade-mark angle claw for digging and flat-surface stabilizing.1/2". Cylinder travel allows for 12" beyond ground level for deep, aggressive anchoring power. The 18" super wide-surface foot pad is designed for the dual purpose of flat surface stabilization and angled recovery anchor stabilization. A single one-man, one-step operation pulls and replaces a single pin to move between the trade-mark angle claw for digging and flat-surface stabilizing.

*This item is available only with an accompanying order of a complete Zacklift unit, which can be found in the Zacklift Underlifts subcategory.

• Valve, Hoses, Fittings, Flipper
• End to end, foot in flat position 57"
• End to end, foot flipped down 59"
• End to end no feet 53"
• Feet width 12"
• Cylinder travel 24"
• Cylinder diameter 3"
• Positioning from ground level 12"
• Travel beyond ground level 12"
• Recommended mounting angle 15 degrees
• Outer tube diameter 5 x 5 x 3/8"
• Inner tube diameter 4 x 4 x 3/8"
• Cylinder output at 2600 psi. 38,000#
• P.O. Checks Yes
• Two valve sections Yes
• Hoses, fittings from legs to valves Yes
• Required gallons per minute 3 to 15