Electric Clutch used with Serpentine Belt for Clutch Pump Applications.
NOTE TO INSTALLER
BURNISHING: Clutches will need a short burnishing period to generate the rated
torque. This is a process of cycling the clutch to slightly wear the friction
surfaces. This allows full contact and maximum magnetic attraction required for
rated torque (or more). TO AVOID BURNING OR HEAT DISTORTION, THE FOLLOWING
PROCEDURE IS RECOMMENDED: After clutch is installed, run at 1000-1200 RPM.
Cycle the clutch on/off at the rate of 10 seconds on - 10 seconds off for a
minimum of 50-100 cycles.
