Free shipping is only valid on total purchases of $199 or more and ground shipments within the contiguous 48 states for products weighing less than 150 lbs. Special handling fees may be required for some products.Shipping fees will be added for all orders under $199 or that include oversized items or any item of 150 lbs or more. Please contact customer service if you have any questions.
This Thrust Washer from Miller Industries is used in the wheel lift assembly of
Century 20 Series Car Carriers and Challenger 4800 Series Wreckers. The thrust
washer measures 5-1/2" diameter, 1" width, and 1/16" thick. Please see the
brochure tab for a list of breakdowns.
This Pivot Pin Bushing from Miller Industries is used in the wheel lift
assembly of Century 20 Series Car Carriers and Challenger 4800 Series Wreckers.
The bushing is used with a pivot pin and goes on the inner boom weldment during
assembly.
This Bearing from Miller Industries is used on the Wheel Lift Assembly of
Challenger 4800 Series Wreckers. It has an outside diameter of 2.5" and an
inside diameter of 2", giving it a thickness of .25". The height of the bearing
is 2". Please see the brochure tab for breakdowns.
These are the wear pads for the inner and outer booms of the wrecker. These
Wear Pads will fit the following wreckers by Miller Industries: Century Express
300 Series, EB4 Express, EB4 6500, Modular Express 300 Series, Formula I,
Duplex Tilt 411 & 412, Formula 6500 - 600 Series, Midnight Express, Challenger
Express 4300 Series, 4700 Series, 4800 Series, Holmes 440 Series, DFT 400, HP
552, DFT 650, and Vulcan Modular 806 and 807. See Brochures for reference chart
. Each Wear Pad sold separately.