Parker Clutch Pump Rear Port P315 326-9110-214, S16mb P12mb.
This is the Pump Only
NOTE TO INSTALLER Clutches will need a short burnishing period to generate the rated torque. This is a process of cycling the clutch to slightly wear the friction surfaces. This allows full contact and maximum magnetic attraction required for rated torque (or more).
BURNISHING-TO AVOID BURNING OR HEAT DISTORTION, THE FOLLOWING PROCEDURE IS RECOMMENDED: After clutch is installed, run at 1000-1200 RPM. Cycle the clutch on/off at the rate of 10 seconds on - 10 seconds off for a minimum of 50-100 cycles.
- Model Number: 326-9110-214
- Port Side: Rear
- Mount: A
- Gallons Per Minute: 9
- Cubic Inch Displacement: 1.09
- Center Section Thicken: 1 1/4"
- Apperance: Gray Cast
- Clockwise Rotation
- 7/8" Tapered shaft with a woodruff keyway
Where it can be used: 700001, 700002, 700003, 700004, 700005, 700006, 700007, 700008, 700009, 700010, 700012, 700013, 700014, 700015, 700016, 700017, 700018, 700020, 700025, 700026, 700027, 700030, 700031, 700032, 700034, 700035, 700036, 700038, 700039, 700040, 700041, 700042, 700046, 700063, 700065, 700067, 700068, 700069, 700070, 700071, 700072, 700073, 700074, 700075, 700076, 700078, 700083, 700087, 700088, 700089, 700090, 700091, 700099, 700300, 700318, 700319, 700322, 700323, 700325, 700326, 700442, 700445, 700449, 700450, 700451, 700452, 700454, 700455, 700456, 700457, 700458, 700460, 700462, 700465, 700466, 700468 700469, 700341, 700347, 700349, 700362, 700366, 700369, 700371, 700374, 700379, 700382, 700383, 700386, 700387, 700388, 700389, 700401, 700402, 700403, 700404, 700406, 700407, 700413, 700414, 700415, 700417, 700418, 700421, 700422, 700424, 700425, 700426, 700494, 700495, 700496, 700501, 700502, 700503, 700505, 700506, 700507, 700511, 700516, 700517, 700518, 700524, 700529, 700535, 700552, 700560