Wiring Harnesses

This three-prong, right angle clip pigtail provides power connection for sealed lights, specifically combination stop, turn and tail lights. The red and black lead wires are bare for making power connection. Red is turn signal, and black is tail signal. The white ground wire has #10 ring terminal at the end.

These are Continuous Wire Harness Rolls, by Maxxima. These Harnesses come with various connects an different length leads. These light harness leads are sold as each. Enter the number of leads into the quantity field then add to your cart.

2 Pin Clearance Marker Connector, from Maxxima.

Power Up Products resistor load kit produces the same draw as an incandescent lamp. Set to flash at a rate determined by the direct current drawn by the lamp load. Flashes at a rapid rate to indicate the burned out lamp. Each resistor is rated to 30 watts. Mounting brackets included.

3-Pin Right Angle STT Plug with 10" Leads from Maxxima. This part can be used to replace Part Number M50900-X.

3-Pin Delphi Connector for M63123 Series Side Turn/Marker Light from Panor Corp.

3-Pin Load Equalizer by Maxxima. When replacing an incandescent turn signal or other flashing light with an LED light, the amp draw of the LED light is so low that sometimes it will flash too slow or too fast, or not flash at all. This load equalizer will level out the amp draw with the flasher module to allow the LED light to flash at the correct speed.

2 Pin Right Angle Connector with Two .180 Male Bullet Connectors, from Maxxima.

3 Pin Male to Male Grote Adapter Harness, from Maxxima.

3 Pin Straight PL-3 Plug with 10" Leads, from Maxxima.

Please Note: Product Discontinued - ALL SALES FINAL!

Keeps water, salt and other corrosives from LED lamps. 8" 16 gauge GPT wire; tin plated brass terminals. Stripped end and ring terminal Fit 'N Forget S.S. plug.

Grand General 0.180 diameter female double bullet receptacle wiring harnesses with 4 inch spacing per plug and designed for use with 0.180 diameter male bullet plugs on most lights. These plugs are made of 18-Ga UL listed wire with one black and one white wire and have specially designed rounded prong tips for easy installation and help to secure the connection.

Keeps water, salt and other corrosives from LED lamps. Combine with LED lamps for Lifetime Lighting Warranty eligibility. 5" 16 gauge GPT wire with tin plated brass bullets/receptacles. Built as a Fit 'N Forget M/C .180 bullet terminal plug.

Marker clearance plug is used in space limited areas. Built as a 7" 16 gauge GPT wire with tin plated brass terminals.

For use with double contact sealed incandescent lamps. Plug is a 11" of 16 gauge GPT wire with tin plated brass terminals.

3 Pin Male/Female Extension Harness, from Maxxima.

Right angle design for use in limited space areas. 6.5" 16 gauge GPT wire with tin plated brass terminals. Built as a marker clearance PL-10 right angle plug with a stripped end and ring terminal connection.

Cable extension fits exclusively to the Race Sport Light RGB+W Rock Light Kits for extending LED ColorSmart pods on larger vehicles.

Keeps water, salt and other corrosives from LED lamps. 8.5" 16 gauge GPT wire with tin plated brass terminals. Built with PL-3 Fit 'N Forget connections.

Keeps water, salt and other corrosives from LED lamps. 8" 16 gauge GPT wire; tin plated brass terminals. The connector is a .180 bullet and ring terminal Fit 'N Forget S.S. plug.

For use with double contact sealed incandescent lamps. Built as an 11" 16 gauge GPT wire with tin plated brass terminals. PL-3 stripped end and ring terminal plug.

For use in space limited areas. 16 gauge GPT wire with tin plated brass terminals. Built as a PL-10 stripped end & ring terminal plug.

Keeps water, salt and other corrosives from LED lamps. 8" 16 gauge GPT wire; tin plated brass terminals. Female PL-3 Fit 'N Forget plug.

This SafeAll replacement part is a wire harness for the emergency strobe lights on the Traffic Commander message board. This electrical assembly powers the light bar and communicates between the SC8 controller and the flashing warning lights. This part ensures your Traffic Commander is functioning properly.

Cable extension fits exclusively to the Race Sport Light RGB+W Rock Light Kits for extending LED ColorSmart pods on larger vehicles.

Cable extension fits exclusively to the Race Sport Light RGB+W Rock Light Kits for extending LED ColorSmart pods on larger vehicles.

Keeps water, salt and other corrosives from LED lamps. Combine with LED lamps for Lifetime Lighting Warranty eligibility. 5" 16 gauge GPT wire with tin plated brass bullets/receptacles. Built as a Fit 'N Forget M/C .180 bullet terminal and ring terminal plug.

This SafeAll replacement part is a wiring harness for the display modules on the Traffic Commander message board. Supplying power and communicating commands, this harness connects the SC8 controller to the four LED bricks which make up the sign. This replacement part ensures your Traffic Commander is functioning properly.

For use with single contact sealed incandescent lamps. Built as an 11" 16 gauge GPT wire with tin plated brass terminals. PL-2 stripped end and ring terminal plug.

Twin Female .180 Bullet 12" Lead Continuous Wiring Harness, from Maxxima. 100 Per Roll.

Keeps water, salt and other corrosives from LED lamps. Combine with LED lamps for Lifetime Lighting Warranty eligibility. Used to Adapt LED lamps to conventional plug harness systems. 4" 16 gauge GPT wire with tin plated brass terminals. Built with Fit 'N Forget M/C and female PL-10 connections.

Cable extension fits exclusively to the Race Sport Light RGB+W Rock Light Kits for extending LED ColorSmart pods on larger vehicles.

Introducing the Federal Signal 8200S/4200S SignalMaster Discrete Wire Cable, the perfect solution for seamless connectivity and control of your vehicle's lighting system. This discrete wire cable is designed to effortlessly integrate with the Federal Signal SignalMaster series, providing a reliable and efficient communication link between your vehicle's control panel and the lighting modules.