96" Gas Slide-In Spreader, Dimensions; 113" x 47" x 32.5", Weight; 945 lbs., Conveyor Feed Mechanism, 11.5" Polymer Spinner, Spread Width; 2-30 feet, Standard Chute, Recommended Use; 3/4 or 1-Ton Trucks

• Hopper spreaders are completely self-contained, ultra-durable spreader units designed for ice and snow control
• The rugged design allows for use with salt, sand and other materials
• The complete assembly mounts easily on pickup, dump and platform trucks
• STEEL MATERIAL HOPPER - Electrically welded 12-gauge ends and steel sides sloped at 45? are constructed with channel formed top edges
• 12-gauge vertical supports add extra strength to the unit
• The single lift point on the cross support beam is located at the unit's center of gravity to allow for easy loading and unloading
• The floor is constructed of 10-gauge steel
• SD-1400050 - 96" Spreaders - Body Side Length, 8'; Overall Length, 113"; Width, 47"; Height, 32 -1/2"
• Recommended Use, 3/4 or 1-Ton Trucks
• CONVEYOR - The conveyor is made of 12"wide all-steel pintle chain with 3/16"x 3/4"cross bars
• Chain strength is 11,000 lbs.per strand;22,000 lbs. total weight
• Drive sprockets are 6-tooth cast iron, on a 1-1/8" diameter shaft
• Conveyor chain has an adjustment range of 3-1/2"
• The drive shaft has heavy-duty, sealed, self-aligning ball bearings with grease fittings
• Idler drum has heavy-duty 1" diameter ball bearings
• CONVEYOR GEAR CASE - Gear is constructed of aluminum bronze, worm gear is hardened steel and ground
• Housing is made of durable cast iron
• Gear ratio is 20:1 with 1" input shaft and 1-1/8"output shaft on tapered roller bearings
• SPINNER CHUTE ASSEMBLY - A polymer disc with four fins is connected to a 3/4"diameter shaft secured on two pillow block bearings
• The spreading material is guided from the conveyor to the spinner plate through an enclosed 12-gauge chute with internal and external deflectors
• Adjustable deflectors allow for complete directional spread control and full or compact spread
• Total spread radius ranges from 2' to 25'
• The extra wide rear deflector protects the rear and under carriage of the vehicle
• FEEDGATE - Lever operated with a friction lock for accurate adjustment
• ENGINE - Heavy-duty 10.5 horsepower industrial/commercial Briggs & Stratton gasoline engine
• Engine comes equipped with alternator and 12 volt electric starter with in-cab start/stop and electric throttle control (standard)
• Entire engine is completely protected by the convenient hinged hood
• ELECTRIC THROTTLE CONTROL - Throttle control unit allows for full-range of throttle settings,including idle and full choke,via the in-cab hopper control box
• Use of electric throttle control eliminates cable freezing, binding and breaking
• CLUTCH - 12 volt DC electric clutch has a three-position in-cab switch, for greater control and material economy
• Also allows for low speed operation and spot spreading
  
  Available in the following sizes
  
  

  Item #	Capacity	Construction
  SD-1400200SS	1.5 cu.yds.	Stainless Steel
  SD-1400050SS	2.0 cu.yds.	Stainless Steel
  SD-1400400	2.0 cu.yds.	Poly
  SD-1400050	2.0 cu.yds.	Carbon Steel
  SD-1400300SS	2.5 cu.yds.	Stainless Steel