Tail Light Assemblies & Wiring Harnesses

This Miller Industries product is a left side tail light assembly for car carriers.

This Miller Industries product is a full assembly of the left side tail light for a car carrier.

This is a Miller Industries license plate light. It is designed to fit any Century or Vulcan LCG Series Car Carrier. Fits into the Tail Light.

This is an LED License Plate Light Kit from Miller Industries. It is LED and can be applicable to most Century or Vulcan car carriers.

This is a Miller Industries tail light face plate for the right hand side of any car carrier excluding the LCG Series. It is available in either black painted steel or stainless steel. This polished stainless steel will not rust and it uses a new style grommet type of back-up alarm. The light configuration is horizontal but vertical is also available (see part # 12-0721340). This part can be used to replace part number 12-0721761.

This is a Underbody Hose Tray for Earlier Challenger and Champion Car Carriers by Miller Industries. It is used on steel beds.This tray will be cut into three pieces for economical shipment

This Miller Industries product is a replacement spacer plate.

A high power LED light. Mounts to the body using screws (not included). Sealed electronics are weather resistant. Includes a plastic black bezel, flange-mount, and a short wire. Draws low energy, operating on just .5A. Standard Vehicle Power: 12V DC

This Miller Industries product is a full assembly of the left hand side of a tail light section on a car carrier. It is designed for Vulcan Car Carriers. It includes all the necessary parts to replace the entire tail light section. This product bolts into the mounting bracket which is attached to the subframe of the carrier.

This carrier light bar comes with three light lenses attached to it. It is used on the Tilt Frame Assembly of Vulcan 10 Series Steel & Aluminum Car Carriers made between 2003 and 2005. See the features below for a list of assemblies and see the brochure tab for breakdowns.

This harness is for a 22' (20 Series) Century car carrier. It contains 2 hoses and wiring, preassembled and ready to go. This part supplies the power to operate the main winch.

This harness is for a 24' (20 Series) car carrier. It contains 2 hoses and wiring, preassembled and ready to go. This part supplies the power to operate the main winch.

This is a Miller bed tilt cylinder, for a 30 series.

This is a Clearance Light Grommet Kit that can be used on Miller Carriers.

This Tail Light Housing has two holes plus a marker light hole. It is made from stainless steel, so it will last for years. This housing replaces old style heavy duty light housings.

This is a Underbody Hose Tray for Earlier Challenger and Champion Car Carriers by Miller Industries. This is used on Aluminum Beds.This part will be cut into three sections for economical shipment. Replaces part number 12-0704799.

This Miller Industries product is the tail light housing and stabilizer for Century or Vulcan 15, 20, and 30 Series Car Carriers (Prior to 2006). Its painted black steel shell houses both the right and left side tail light components, as well as the face plate. Prior to 2006 this part also is known as the stabilizer. 2006 and newer models have the tail light housings bolted onto the subframe unit. See features for additional information.