Century

This is a Miller seal kit. It is for the It27B cylinder.

This is a Miller power beyond sleeve, Wavoil. It comes with a built-in pressure cartridge.

This is a cylinder hydraulic tilt.

This is a 16" long subframe bearing pad by Miller Industries. It is one of the replacement pads for a 2010 or newer 10 Series Car Carrier. This part is included in the Bearing Pad Kit

Century owner's manual for Formula 6500 - 600 series wreckers. It contains installation, operation, maintenance and parts information.

This is a replacement Retaining Pin from Miller Industries.

This Seal Kit from Miller Industries is used on a Holmac Cylinder.

This 90? Elbow from Miller Industries is 1/2" x 1/4" and it is used in the Hydraulics Assembly and the Tow Bar Assembly of several Miller Car Carriers. These Carriers include Challenger, Century, Champion, Holmes, and Vulcan. See the features below for a list of assemblies and see the brochure tab for breakdowns.

This is a replacement grade 8 hex nut.

This is a replacement nylatron pad from Miller.

This is a Miller Industries control box hood assembly with a black finish. It includes both the driver and passenger side hoods as well as the channel box connecting the two. It is designed for all Century/Vulcan Car Carriers 2005 & newer (Excluding LCG). See Features for part numbers this assembly includes.

This Wheel Lift Cylinder from Miller Industries is used on the assembly of several Century Car Carriers. These include 15, and 20 Series Car Carriers. See the features below for a full list of carriers and see the brochure tab for breakdowns.

This is the Hair Pin for the Boom Lift Cylinder Pin. This hair pin keeps the clevis pin from pulling out and letting the cylinder fall off the boom.

This is a replacement swivel boom end assembly for Century medium duty wreckers by Miller Industries. This assembly will fit the Century 5130/5230, 1624, and 1040B. To view the part schematics click on the Brochure tab above. This part can be used to replace Part Numbers: 12-0900431 and 12-0900432.

This is the Boom Lift Cylinder on the Century Formula 6500 - 600 Series light duty wrecker by Miller Industries. This cylinder raises and lowers the boom on your wrecker. To view the part schematic click on the Brochure tab.

This is a replacement boom lift cylinder upper pin on Century and Challenger Heavy Duty Integrated Wreckers by Miller Industries. This pin goes through the rode end of the cylinder and attaches the lift cylinder to the main recovery boom outer weldment of the wrecker. To view the models this pin fits, see Features below. To view the part schematics, see the Brochure tab.

This is a 1/4-20X3/4 Hhcs Gr5 Zp from Miller Industries.

Miller Industires DP 11309 Decal.

This is a 3/4-10 X 6.5 Hhcs Gr5 Zp from Miller Industries.

This is a Miller cable assembly.