Chevron

Note: Special Handling Fees Apply

Wear pad , 1/4" x 3" x 96" long

This is a replacement aluminum hood 6 hole Chevron crossrod.

This is a replacement LCG bed extend cylinder seal kit.

This is a replacement 58 link hose track for Century and Chevron car carriers by Miller Industries. This hose track will fit on the Century 16 Series LCG Generation II Carrier. This track also fits the Chevron Series 10 and Series 16 LCG Generation II Carriers. To view the specific models this hose track fits, see Features below. To view the part schematics cee the Brochure tab.

This is an inner tube slide pad for the top side of the wheel lift on the Century 12 & 16 Series LCG Generation II Car Carrier. Each pad sold separately.

This is a pin, 5/16 safety snap, holds carrier L-arm in holder.

This is a nut, 1/2, 20 unf plated.

This is a replacement Side Puller Overlay decal for the passenger side.

This is a replacement Yoke Leaf Spring for the wheel lift of your wrecker. Does not work with auto L-arms.

This is a replacement plate for A9009P.

5/8"-11 Grade 8 Yellow Zinc Finish NE Steel Nylon Insert Lock Nut.

This is a replacement wheel lift inner boom weldment for the chevron 408 light duty wreckers by Miller Industries. This inner tube is used with the outer tube and crossbar to lift a vehicle. To view the specific models this boom weldment fits, see Features below. To view the part schematics, see the Brochure tab.

This is a replacement 6 inch pulley.

This is a pintle hitch assembly w/lugs for optional fifth wheel hitch & pin. This item does not include the pintle and ball, see part #15-A3020. For a complete kit including the hitch, pintle and ball see part #15-663705G-KIT.

This is a replacement 7/8" nylok nut by Chevron.

This is a replacement 37" control rod weld't.

This is a replacement 30mm poly clamp, with steel screws.

This is a replacement mega flex hydraulic hose that measures 10.5" by Miller Industries. This is used on auto load wheel lifts.

Note: Special Handling Fees Apply

This is a replacement Chevron steel bed wear pad.

• Length: 96"
• Width: 2.5"
• Height: 0.27"
• Other Dimensions: .25" holes

Nylon lock nut from Miller Industries.

1" External snap ring.

This is a aluminum 5 hole crossrod.

These are the screws that holds the wear pads to the subframe of your Miller carrier. To replace all of the wear pad screws on your bed it will require 42 screws.

This is a replacement mega flex hose 35".

This is a 27-3/4" control rod weldment.