Free shipping is only valid on total purchases of $199 or more and ground shipments within the contiguous 48 states for products weighing less than 150 lbs. Special handling fees may be required for some products.Shipping fees will be added for all orders under $199 or that include oversized items or any item of 150 lbs or more. Please contact customer service if you have any questions.
Replacement parts and hardware for your hydraulic system will keep the cylinders and winches operating as they should on your wrecker or car carrier. Whether it’s a full hydraulic system or a small elbow fitting, count on Zip’s AW Direct to carry the parts you need to get back to work.
DewEze A Clutch Pump Mounting Kit 2011-2013 Ford 6.2L Gas Side Port Complete Kit 9 or 12 GPM Clutch Pump (Max. Capacity at 1600 R.P.M) For 11-13 Ford 6.2 V8 Gas Engine in F250 and F350. (Basic pump kits include: pump, idler pulley, clutch, serpentine belt, crankshaft pulley, pump mtg. Bracket's as needed.
DewEze Clutch Pump Kit For 2011 Ford F250-550 With 6.7L Diesel Engine (Up to 17 G.P.M. at 1600 R.P.M.) NOTE: DOES NOT Fit Dual Alternator Applications. (Basic pump kits include: pump, idler pulley, clutch, serpentine belt, crankshaft pulley, pump mtg. Bracket's as needed.
This Hydraulic Fitting Connector from Miller Industries measures 8MJ x 8MP and 1/2" SAE x 1/2" JIC. It is used on the Hydraulics Assembly of several Miller Car Carriers. These Carriers include Century 10, 15, 20, and 30 Series Carriers, Champion Carriers, and Vulcan 10 Series Extreme Angle Carriers. See the features below for a full list of carriers and see the brochure tab for breakdowns.
This 5/8" x 1/2" Straight Hydraulics Connector from Miller Industries is used on the Hydraulics Assembly of Challenger, Century, Champion, Holmes, and Vulcan Car Carriers. See the features below for a list of assemblies and see the brochure tab for breakdowns. This part can be used to replace Part Number 12-0300789.
This Muncie Hot Shift Power Take Off (PTO) is for installation on Allison automatic transmission when installing a Miller Car Carrier built after 06/15/2015 or a Miller Industries with a 1" x 15 spline pump shaft.
This Hydraulic Elbow Fitting from Miller Industries is used to connect the hose assembly to the bed extend cylinder on Century 10, 15, 20, and 30 Series Car Carriers. See the features below for a list of assemblies and see the brochure tab for breakdowns.
This 1/4" x 21" Hose Assembly from Miller Industries is used to connect the Bed Lift Cylinder on the Hydraulics Assembly of several Miller Car Carriers. These include Challenger, Century, Champion, Holmes, and Vulcan carriers. See the features below for a full list of carriers and see the brochure tab for breakdowns.
Pilot Operated Check Valves are similar to normal check valves, except they can be opened from an external pilot pressure. Similiar to standard Check Valves, P.O. Check Valves block flow in one direction.
This Hydraulic Elbow Fitting from Miller Industries is used to connect a hose assembly to the tilt cylinder on the Hydraulics Assembly of Century, Champion, and Vulcan Car Carriers. See the features below for a full list of carriers and see the brochure tab for breakdowns.
This 1/2" x 128" Hose Assembly from Miller Industries is used to connect the bed extend cylinder to your valve spool on the Hydraulics Assembly of several Miller Car Carriers. These include Century, Challenger, Champion, Holmes, and Vulcan carriers. See the features below for a full list of carriers and see the brochure tab for breakdowns.