Century

Note: Special Handling Fees Apply

This Outer Left Hand Crosstube Assembly fits Century Formula 6000 and 6500 Series, Holmes DFT-650 wheel lifts, and Century 20 Series car carriers. This crosstube accepts a 6,000 lb. Slide-In L-Arm, 12-0802606. You can also get a Right Hand Outer Slide-In Crosstube, 12-0904691, by clicking here.

• 31-1/2"
• Fits 3-1/2" x 3-1/2" square tube
• Century 6,000 lb. Slide-In L-Arm Style

This is a single winch clutch release from Miller Industries. The release will allow the operator to slowly and safely release tension on the cable without damaging your winch.

This is a replacement hydraulic reservoir centering mount on heavy duty wreckers by Miller Industries. This rubber center bonded mount absorbs the stress of the hydraulic tank being mounting to the frame of the wrecker. To see which specific models this mount will fit, please see Features below. To view the part schematics click on the Brochure tab above.

This is a replacement seal kit for Dp55313.

This backup light fits the Century and Vulcan 16 series car carriers.

This is a Miller Industries Control Box hood for the Passenger side of any Century/Vulcan Car Carrier 2005 & newer (Excluding LCG). It houses a 5-spool system and is galvanized finish.

Miller Industries ?" x 1.5" clevis pin.

This is a replacement Miller cable assembly. It is a 3 stage.

This is 3 Spool Valve from Parker. This valve is use to run the hydraulic wheel lift functions on many Century and Challenger Wreckers. See related schematics to ensure fitment.

This is a Miller 1 1/2(1.510) x .062 shim washer.

This Subframe Rail Plug from Miller Industries is used on the Frame Assembly of Century and Vulcan Car Carriers. See the features below for a full list of carriers and see the brochure tab for breakdowns.

This is a Miller 1 cam lock plunger pin.

This is a replacement Bearing from Miller Industries that is used on the Formula IIT Underlift Assembly of Century 614 Formula IIT Wreckers.

This is a Miller underlift tilt cylinder. This cylinder is used on heavy duty wreckers with an integrated underlift. This cylinder attaches to the underlift tower weldment and the boom of the wrecker allowing the underlift to tilt in or out.

This is a universal replacement snap ring 1.5 5100-150.

This is a hydraulic component that contains 2 hoses and all wiring already preassembled. The hoses measure 3/8" and this harness is for 22' Century 10 and 15 series car carriers. This part supplies power to the main winch.

This is a Wavoil power beyond sleeve.

This is a Miller hex head cap screw. It is grade 5 and zinc plated. It measures 3/8-16 x 1.5.

This is a 3/8-16 J-nut tinnerman from Miller Industries.

This is a replacement Hanson striker pin kit.

This is a 12-3/16 inch gas cylinder from Miller Industries.

This Miller Industries product is a left side tail light assembly for car carriers.

Aluminum Dress Up Kit (Tailgate Only) for the Body of a 7035, 9055. Includes Left Tailgate Panel, Right Tailgate Panel, and Tower Panel.

Note: Special Handling Fees Apply

This is a swivel boom assembly for Century 1140, 1130, 5030T35, and 7035 fits either side from Miller Industries.

• Fits Century 1140 & 1130/ SDU4 & LDU, 5030T35, 7035 2-speed wreckers either side